top of page

Product Description:

  • DIY testing for bacteria or mold contamination in indoor environments.

  • Suitable for testing contamination in air, surfaces and water.

  • Test results indicate microbial concentration levels.

  • Accurate results within 5 days.



  • Use for testing air streams, surfaces and water

  • Monitor air handling system regularly and accurately


Directions for use:

  • Remove dip slide from plastic container

  • Air testing - hold the dip slide by the larger tab and place one side in front of the air stream (pictured below) for one minute. Place opposite side in front of air-stream for another minute

  • Surface testing - hold the dip slide by the tab at each end, press on side against the surface;
    Use ribbed neck to bend dip slide to allow for full contact with surface;
    Repeat with the opposite side on an area close to the first site of testing

  • Water testing - hold the dip slide by the larger tab;
    Either immerse the dip slide into the water for 10 seconds OR hold the dip slide under running water to cover both sides OR spray water to cover both sides

  • Replace dip slide into plastic container and seal firmly

  • Complete label and adhere to plastic container

  • Incubate test sample by placing inside a box; Allow to warm from 25°C to 32°C for 48 to 120 hours


Refer to in pack chart for interpretation of results


Download Brochure

Test Kit For Bacteria and Mold

SKU: SA-630058
    bottom of page